Jordahl

Precise recesses with Innogain products

If recesses or holes in reinforced concrete are required, these have up until now been generated by a shuttering formwork of pipes, plates or recess bodies, e.g. made of polystyrene, or by labour-intensive drilling, which is damaging to health and the environment.

The results of these procedures are often unsatisfactory, e. g. the effects are poor dimensional accuracy and angularity of the recesses, abortive drilling, or even damage to the reinforcement.

Recess unit with steel core and flexible covering

Jordahl GmbH now offers a fascinating and innovative solution to this issue due to their...

Related articles:

Issue 2015-04 Jordahl

Innovation award for re-useable recess units

At the end of February, Jordahl Innogain was awarded the Innovation Award of the Supplier Industry for Building Parts at the 59th Ulmer Beton Tage. This prize is awarded annually by the FBF...

more
Issue 2015-03 BAU 2015

Full halls, good atmosphere

Normally, the big run takes place at the second day of the trade fair. However, at BAU 2015 visitors were already streaming through the aisles and stands on the first day. According to the organizer...

more
Issue 2017-06 Jordahl

Fastening anchor channels with installation cones

High quality demands are placed on precast elements made of reinforced concrete. They pose a particularly high challenge with regard to the geometry. This also applies to the built-in components such...

more
Issue 2015-04

Real progress

The moment chewing gum with a new flavor goes on sale, marketing talks about an innovation. Runnning shoes in a new color – again an innovation. The old pop song with new rhythm – innovation. Such...

more

Pfeifer thread system with expanded range of accessories: Architecturally pleasing locking screw for lifting anchors

The architecturally pleasing locking screws of Pfeifer made of stainless steel are able to close recesses at precast elements, which are due to the fixing screws, in an appealing way. For this...

more