Max Frank

New shear force dowel as modular system

Designers are often faced with the challenge to find a solution for the transverse force transmission of expansion joints that is flawless as regards statics, easy to install, and cost-effective at the same time. The new Egcodorn shear force dowel system of Frank allows the designer to dimension the shear force dowel according to the actual shear force and joint width. The system enables varying the dowel diameter and the anchor body of the Egcodorn as required for an optimum load transmission, e.g., large dowel diameter, small anchor body with a large joint width. Consequently, over...

Related articles:

Issue 2011-10 Stair landing and exterior corridor decoupling

Shear force dowel Egcotritt for highest demands on impact sound insulation

The reduction of the impact sound is a great challenge when planning and constructing a residential project. The shear force dowel Egcotritt of Frank provides a solution for the acoustic decoupling of...

more
Issue 2012-09

Efficient punching and shear reinforcement system

Peikko comes out with a new punching and shear reinforcement system called “PSB-F”, which is especially designed for the requirements of precast concrete factories and has been granted the European...

more
Issue 2012-10 VBBF Congress

Reinforcement seminar again a success

The relatively new association for the promotion and development of fastening systems, reinforcement, and façade engineering (Verein zur Förderung und Entwicklung der Befestigungs-, Bewehrungs- und...

more
Issue 2019-09 HALFEN

Innovative punching shear reinforcement for foundations

The larger the buildings, the higher the shear forces that act at points on reinforced-concrete slabs. To prevent punching of columns through concrete slabs, punching shear reinforcement, commonly in...

more
Issue 2021-11 Monday, 15th November ? Innovation workshop (6)

New European Assesment for punching shear reinforcement

Flat slabs made of reinforced concrete are supported directly on columns. The total height of the slab construction is reduced and the formwork effort is simplified because beams are done away with....

more