Max Frank

New shear force dowel as modular system

Designers are often faced with the challenge to find a solution for the transverse force transmission of expansion joints that is flawless as regards statics, easy to install, and cost-effective at the same time. The new Egcodorn shear force dowel system of Frank allows the designer to dimension the shear force dowel according to the actual shear force and joint width. The system enables varying the dowel diameter and the anchor body of the Egcodorn as required for an optimum load transmission, e.g., large dowel diameter, small anchor body with a large joint width. Consequently, over...

Related articles:

Issue 2011-10 Stair landing and exterior corridor decoupling

Shear force dowel Egcotritt for highest demands on impact sound insulation

The reduction of the impact sound is a great challenge when planning and constructing a residential project. The shear force dowel Egcotritt of Frank provides a solution for the acoustic decoupling of...

more
Issue 2017-02 Improved design models as against EC 2

Increase in the load-bearing capacity of shear stud assemblies

A purposefully applied supplementary reinforcement can considerably increase the load-bearing capacity of fastenings embedded in concrete under tension load (mode of failure: concrete cone failure)...

more
Issue 2021-02

Punching shear behavior of steel fiber reinforced flat slabs in combination with punching shear reinforcement

The guideline “Steel Fibre Reinforced Concrete” published by the German Committee for Reinforced Concrete (DAfStb) in 2012 regulates the punching shear design of steel fiber reinforced flat slabs...

more
Issue 2012-11 Jordahl GmbH

New name, well-proven quality

After a company history lasting for more than 100 years now, Deutsche Kahneisen Ge- sellschaft based in Berlin changes its name and with immediate effect operates under the name Jordahl GmbH. The...

more
Issue 2021-02

Punching shear reinforcement in crosswise arrangement – Effective or impermissible?

Stud rails used as punching shear reinforcement in flat slabs are arranged radially in Germany. A crosswise arrangement in the layout of the reinforcement elements, as it is common practice in North...

more