Day 3: Donnerstag, 20th February 2014

Concrete in Structural Engineering

171 Waterproof concrete basements – Checklist for effective design by classification
Weiße Wannen – Checkliste für effektives Planen durch Klassifizierungen
Dipl.-Ing. Karsten Ebeling
174 Shear design for biaxial loading and circular sections
Querkraftbemessung bei zweiachsiger Beanspruchung oder Kreisquerschnitten
Prof. Dr.-Ing. Peter Mark
176 Simplifying design – Combinations of actions relevant to the design of reinforced-concrete members in conventional multi-story construction
Einfacher Planen – Maßgebende Einwirkungskombinationen zur Bemessung von Stahlbetonbauteilen im üblichen Hochbau
Prof....

Related articles:

Issue 2019-02 New experimental results on punching shear behavior of flat slabs with varying amount of punching shear reinforcement

Reduction of punching shear reinforcement

With introduction of Eurocode 2 in Germany, the punching shear design provisions for flat slabs were revised. In consequence of limited anchorage conditions of punching shear reinforcement elements in...

more
Issue 2018-02 Punching shear behavior of footings with a varying amount of punching shear reinforcement

Experimental investigations

The punching shear design provisions for footings and ground slabs were revised with the introduction of Eurocode 2 in Germany. In contrast to previous German codes, the location of the control...

more
Issue 2021-02

Punching shear behavior of steel fiber reinforced flat slabs in combination with punching shear reinforcement

The guideline “Steel Fibre Reinforced Concrete” published by the German Committee for Reinforced Concrete (DAfStb) in 2012 regulates the punching shear design of steel fiber reinforced flat slabs...

more
Issue 2011-03 fib Bulletin 57

Shear and punching shear in RC and FRC elements

fib Bulletin 57 is a collection of contributions from a workshop on „Recent developments on shear and punching shear in RC and FRC elements“, held in October 2010 and attended by 72 participants...

more
Issue 2017-02 Flat slabs and foundations

New punching shear reinforcement systems

The structural design of flat slab systems is usually governed by the punching shear resistance of the slab. To achieve a sufficient punching shear resistance at reasonable slab thickness, shear...

more