Fastening systems for precast concrete components

The incorporation of fastening elements in precast concrete components intended for underground engineering can already be done during manufacturing. For this purpose, anchor channels and corresponding bolts are a costeffective and simultaneously safe option. Embedding anchor channels in concrete allows without any problems later assembly of installations, supporting of loads or even connecting of precast concrete components among each other.
The Jordahl®-anchor channels with national technical approval offered by Deutsche Kahneisen GmbH allow – in difference to dowels – the transfer of loads to precast components without any damage of the same. The anchor channels are fixed to the formwork. To prevent fresh concrete penetrating in the channel slot, a foam filling is inserted in the channels. Anchor channels are in the position to support loads in all directions at each bolt. Assembly and fine adjustment of the fastening is infinitely variable in longitudinal direction of the channel, allowing to adjust even larger dimensional tolerances easily. Even if cast-in near edge, Jordahl anchor channels yet support high loads. Therefore, these anchor channels are also suitable for filigree or heavily reinforced precast components. Any shrinkage and creeping of the concrete components do not have any influence on the safety of the fastening system. Even cracked concrete in the area of tensile load or dense reinforcement do not affect the load-bearing capacity. In accordance with the specific requirements, anchor channels of the Berlin-based company are made of steel according to German standard DIN EN 10025 or stainless steel according to DIN EN 10088.

Deutsche Kahneisen GmbH
Josefine Niemand
Nobelstraße 51
12057 Berlin/Germany
Tel.: +49 30 682 834 82
Fax: +49 30 682 834 97

Related articles:

06/2017 Jordahl

Fastening anchor channels with installation cones

High quality demands are placed on precast elements made of reinforced concrete. They pose a particularly high challenge with regard to the geometry. This also applies to the built-in components such...


Innovative JTB-LA channel for fastening without anchors for façade construction and in precast concrete elements

The new Jordahl JTB-LA channel with perforated anchors for attaching trapezoidal sheet metal, approved by the German Institute for Construction Engineering (DiBt), enables reliable transfer of forces...

09/2010 Proven Fastening System

Jordahl® Anchor Channels Used in the First Mercedes Plant in Hungary

Production and assembly halls as well as service buildings covering an overall floor space of more than 230,000 sq.m will be constructed. The construction site has the size of roughly 650 soccer...


Anchorless fastening channel – redesigned and verified

With increasing load requirements and, at the same time, significantly reduced installation space, products for load application must be developed which meet the requirements without the need for deep...

05/2015 Jordahl

Efficient fastening for façades

No matter whether large-scale façade elements or narrow balustrade strips are concerned – Jordahl balustrade anchors JBA are already embedded in the precast component at the precast concrete...