WINCO®: A standardized support solution for precast construction
© Peikko
Support details for TT slabs and secondary beams affect formwork and reinforcement detailing from the outset at the precast plant. WINCO® provides a standardized steel corbel for a range of design requirements. The system has General Technical Approval (abZ) and General Construction Technique Permit (aBG) issued by the German Institute for Building Technology (DIBt).
Rectangular precast elements without notches
WINCO® Corbel consists of a compact steel profile with a centrally positioned anchor bar and a welded bearing plate. A large-headed stud transfers the support forces into the precast concrete element. The rectangular component geometry eliminates the need for notches at the beam ends; special formwork is not required. The low construction depth also provides a clean soffit.
Schematic illustration of WINCO® support applications: TT slab, beam or secondary beam, and trough slab.
© Peikko
Efficient precast production and support-free installation on site
The WINCO® Corbel is fully installed at the precast plant. The absence of complex reinforcement arrangements simplifies work preparation and reduces the risk of errors. At the same time, dimensional accuracy is maintained and fewer production steps are required.
No temporary propping is required during the installation of the precast elements on site or when casting the cast-in-situ slab.
WINCO® Corbel with additional reinforcement.
© Peikko
Standardized sizes and tabulated design
WINCO® is available in three load classes: 65, 100 and 130. Design is based on predefined tabulated values and does not require dedicated design software. The additional reinforcement required for each corbel is likewise specified. The standardization makes WINCO® a stock item that can be supplied at short notice.
Good to know: If project-specific requirements exceed the standard application limits, for example regarding loads, dimensions or boundary conditions, Peikko Technical Support can assist with a project-specific design.
WINCO® has a German national technical approval (abZ) and general construction technique permit (aBG), Z-15.6-392, issued by DIBt. WINCO® also meets the R 90 fire resistance requirement making it suitable for use in more sensible areas with specific requirements.
Peikko will showcase WINCO® at BAU 2027 in Munich from 11 to 15 January, Hall A2, Stand 408.
More information
