BCR Building Components Rimmele

Release agent for wetcast slabs

The concrete release agent VD Rapid React is free from silicon and solvents and is available as a ready-to-use emulsion. Thanks to the short cross-linking time of only 30 seconds, the release agent becomes effective already prior to casting. Use of the VD Rapid React, the manufacturer reports, enables savings in consumption of approximately 30%.

Related articles:

Issue 04/2017 SUBMITTED BY: BCR RIMMELE

Innovation: Via Domo Smart Wetcast – ­reinforced polyurethane molds

Since the introduction of the REACH regulation (European Chemicals Regulation), an increasing number of chemicals that formerly contributed to the dimensional stability of polyurethane molds are now...

more

BFT-expert-forum “Wetcast” was a great success

Great participation and high satisfaction values were achieved by the BFT expert forum WetCast 2022. More than 50 experts from concrete block- and precast plants as well as from companies of the...

more
Issue 02/2013 BCR Building Components Rimmele GmbH

Wet-cast molds for concrete slabs with a small contour width

Wet-cast slabs upgrade the garden in its visual appearance. They look like natural stone and are individually cast of concrete. They are suitable for terraces and pathways as well as retaining walls....

more
Issue 03/2016 BASF

New release agent with higher flash point launched

Master Builders Solutions does not use any longer flammable solvents for their newly formulated concrete release agents. According to the information given by the manufacturer, they were able to...

more
Issue 07/2022 BFT INTERNATIONAL

BFT-expert-forum “Wetcast” was a great success

Great participation and high satisfaction values were achieved by the BFT expert forum WetCast 2022. More than 50 experts from concrete block- and precast plants as well as from companies of the...

more