Eirich

Mixing and other equipment on display at Intermat 2015

Renowned the world over for its mixers, Eirich will showcase equipment and solutions for a wide range of uses at its redesigned booth (Hall 7, Booth L 014) at this year’s Intermat trade show that will take place from 20 to 25 April in Paris.

If and when required, Eirich mixers can be operated at high tool speeds to ensure optimal pigment distribution and to break down clay lumps in the sand, which, in turn, reduces the frequency of surface defects, and thus reject rates.

For about ten years, there has also been an increasing demand for Eirich equipment on the part of precast producers. Superior...

Related articles:

Issue 06/2021 MASCHINENFABRIK GUSTAV EIRICH

The Eirich mixing system – history, distinctive features, applications

Mixing concrete on an industrial scale requires the use of compulsory mixers. The first models were single-shaft mixers, created around 1870, when J. Monier invented the so-called “iron-reinforced...

more
Issue 03/2010

Maschinenfabrik Gustav Eirich GmbH & Co KG · Hall C1, booth 425/530

At this year‘s bauma Eirich will present the intensive mixers type R12W and R 16 in the new design series that was started at the last bauma with type R12. Overall, the constructional improvements,...

more
Issue 06/2020 MASCHINENFABRIK G. EIRICH

Technical University of Denmark relies on Eirich mixing technology

Since the introduction in 2005 of the “mixer with sequence automation and process data control,” initially known as the “mixer with university control,” more than 50 institutions around the world...

more

Eirich: Dressler precast component factory – a success story

Dressler Bau GmbH, from Aschaffenburg, can look back on over 100 years company history. The development of the precast component factory in Stockstadt has seen EIRICH involved from the very start:...

more
Issue 09/2017 Eirich

Mixing technology for lightweight concrete

The demand for high-quality mixes is increasing. Meeting this demand is often difficult, if not impossible. The reason for this is that mixing processes, as described in the literature, are always...

more