Submitted by: BT innovation

Innovation: BT Q anchor for building with thin walls

The BT Q anchor was developed to transfer maximum possible shear and tensile forces into concrete elements. It is an embedded part and is installed prior to casting and is then embedded, An approval of the anchors in the form of an ETA has been applied for.

Redistribution  of force effect

The currently used anchor consists of a sleeve and an anchorage part, e.g. a pin. In conventional anchors, all loads are always transferred via the central sleeve directly into the surrounding concrete. For that reason, concrete break-out failures begin primarily at the sleeve.  In order to be able to transfer high forces, the anchors must be covered with much concrete. By attaching wings to a headbolt sleeve anchor, the loads transferred into the  sleeve can be transferred more deeply into the structural element. However, of disadvantage would be that uncoated load transfer surfaces would apply pressure on the concrete in the direction of shear force and in this way could lead to premature crack formation in the concrete. In order to allow such crack formation only under very high loading, the anchor is selectively encased with an elastic layer. Selective rubber coating causes the outer sides, the wing arms and the sleeve, to become decoupled from the surrounding concrete and are therefore unable to assert pressure on the concrete.

CONTACT

B.T. innovation GmbH

Sudenburger Wuhne 60

39116 Magdeburg / Germany

Phone: + 49 391 7352 0

info@bt-innovation.de:info@bt-innovation.de%3C/a%3E">

www.bt-innovation.de

Related articles:

Issue 2017-02 Improved design models as against EC 2

Increase in the load-bearing capacity of shear stud assemblies

A purposefully applied supplementary reinforcement can considerably increase the load-bearing capacity of fastenings embedded in concrete under tension load (mode of failure: concrete cone failure)...

more
Issue 2015-04 Submitted by/Eingereicht von: Romex PFM

Innovation: ISATEC earth anchor system

Large-format slabs and paving stones are subjected to enormous loads because they are primarily used in areas where heavy trucks and buses drive, turn or stop. The vehicles’ high own weight and...

more
Issue 2019-12 F. SCHROEDER

Threaded anchors as permanent fastenings for civil engineering works

The company Friedrich Schroeder has extended its product range by adding permanent fastenings that have been provided with evidence of National Technical Approval. The 20 SL threaded anchor with...

more
Issue 2015-05 Jordahl

Efficient fastening for façades

No matter whether large-scale façade elements or narrow balustrade strips are concerned – Jordahl balustrade anchors JBA are already embedded in the precast component at the precast concrete...

more
Issue 2013-05 Max Frank

New shear force dowel as modular system

Designers are often faced with the challenge to find a solution for the transverse force transmission of expansion joints that is flawless as regards statics, easy to install, and cost-effective at...

more